Delta 50-850 instruction manual Assembling Filter and Dust Collection Bags to Drum

Page 8

ASSEMBLING FILTER AND DUST COLLECTION BAGS TO DRUM

1.Hook the loop on the top of filter bag (A) Fig. 18, onto filter bag support rod (B) as shown.

2.Assemble extension rod (C) Fig. 19, onto the end of filter bag support rod (B). Raise support rods (B) and (C), with filter bag (A) attached and place end of support rod

(C) into holes of bracket (D). NOTE: Flared end of filter bag extension rod will prevent the rod from sliding through bracket.

3.Position open end of filter bag (A) Fig. 19, over lip of dust drum (E). Insert locking band (F) Fig. 20, through the loops of filter bag (A) and fasten with clamp (G) as shown in Fig. 21. NOTE: Make certain locking band is positioned in the channel of drum (F) before fastening clamp.

4.Pull up on each retaining clip (A) Fig. 22, and insert the dust collection bag (B) underneath each retaining clip to hold the dust collection bag in place.

5.Place the locking clamp (C) Fig. 22 around dust collection bag and dust collector drum and lock in place.

NOTE: Make certain locking clamp is positioned in the channel of the dust collector drum before locking clamp.

G

E

Fig. 21

A

B

Fig. 18

B

A

D

E

C

Fig. 19

F

A

G

E

Fig. 20

A

BC

Fig. 22

8

Image 8
Contents ½ H.P. Single-Stage Dust Collector General Safety Rules Additional Safety Rules for Dust Collectors Refer to them often Use them to instruct othersUnpacking and Cleaning Hardware not ShownAssembling Casters to Base AssemblyAssembling Blower and Motor Assembly to Base Page Page Assembling Filter and Dust Collection Bags to Drum Connecting Tool to Power Source Power ConnectionsMotor Specifications Grounding InstructionsExtension Cords Minimum Gauge Extension CordCircuit Breaker MaintenanceOperating Controls Accessories PARTS, Service or Warranty Assistance Two Year Limited WarrantyCanadian PORTER-CABLE Delta Service Centers