Delta 50-851 instruction manual Assembly, Assembling Caster Assemblies to Base

ASSEMBLY

WARNING: FOR YOUR OWN SAFETY, DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTIL THE MACHINE IS COMPLETELY ASSEMBLED AND YOU READ AND UNDERSTAND THE ENTIRE INSTRUCTION MANUAL.

ASSEMBLING CASTER ASSEMBLIES TO BASE

1.Align the holes in swivel caster assembly (A) Fig. 4, with four holes in caster bracket (B) located on the underside of base (C). Place a 5/16" lockwasher (E) Fig.

4onto a 5/16-18x5/8" hex head screw (D), then place a 5/16" flat washer (F) onto the hex head screw. Insert the hex head screw through the hole in the wheel caster, thread the hex head screw into the tapped hole in the base, and tighten securely. Repeat this process for the three remaining holes. Assemble the three remaining swivel caster assemblies to the base in the same manner.

2.Fig. 5, illustrates the caster assembled to the base.

ASSEMBLING BLOWER AND MOTOR ASSEMBLY TO BASE

BC

A		F
	E	D
		Fig. 4

Fig. 5

1. Set blower and motor assembly (A) Fig. 6, on base (B).

2. Align mounting holes (C) Fig. 6, at the bottom of blower

and motor assembly (A) with four threaded holes in the

base, three of which are shown at (D). Place a 5/16"

lockwasher (F) Fig. 6, onto a 5/16-18x5/8" hex head

screw (E), then a 5/16" flat washer (G) onto the hex head

A

C

B

screw. Insert the hex head screw through the hole in the
motor assembly, thread the screw into the hole in the
base, and tighten securely. Repeat this process for the
three remaining holes.
3.	Fig. 7, illustrates the blower and motor assembly (A)
fastened to the base.
4.	Apply a bead of silicone sealant around the blower
flange (H) Fig. 7.

DD

E

F

G

Fig. 6

H

A

Fig. 7

5