Delta 50-851 instruction manual Assembling Filter and Dust Collection Bags to Drum

12.Assemble the other end of drum support arm (T) Fig. 16, to base (B). Place a 5/16" lockwasher onto a 5/16-18x5/8" hex head screw (W), insert the hex head screw through drum support arm (T), and thread into base (B). Repeat this process for the remaining hole. NOTE: Do not completely tighten mounting hardware at this time.

13.Assemble the remaining drum support arm to the opposite side of drum and base in the same manner. Tighten all mounting hardware.

14.Fig. 17, illustrates the blower and motor assembly mounted to the base.

ASSEMBLING FILTER AND DUST COLLECTION BAGS TO DRUM

1.Hook the loop on top of filter bag (A) Fig. 18, into filter bag support rod (B) as shown.

2.Assemble extension rod (C) Fig. 19, onto the end of filter bag support rod (B). Raise support rods (B) and (C), with attached filter bag (A) and place end of support rods into holes of bracket (D). NOTE: Flared end of filter bag extension rod will prevent the rod from sliding through bracket.

A

B

Fig. 18

T

B

W

Fig. 16

Fig. 17

B

A

C

D

Fig. 19

8