8.Align mounting holes in drum (N) Fig. 12, with gasket (M), which was assembled in STEP 7. Place a 5/16" lockwasher onto a 5/16-18x5/8" hex head screw, insert screw (P) Fig. 13 through chute (K), thread screw into drum (N) and tighten securely. Repeat this process for the seven remaining holes.
9.Assemble “U” bracket (R) Fig. 14, to side of drum
(N). Place a 5/16" lockwasher then a 5/16" flat washer onto the 5/16-18x5/8" hex head screw. Insert the hex head screw through the hole (S) in the “U” bracket and the hole in the drum, thread a 5/16-18 hex nut onto the screw and tighten securely. Repeat this process for the remaining hole.
10.Align two mounting holes in the top of drum support arm (T) Fig. 15, with two pre-drilled holes in drum (N). Place a 5/16" lockwasher then a 5/16" flat washer onto a 5/16-18x5/8" hex head screw, insert the hex head screw through the hole (V) in drum support and drum. Thread a 5/16-18 hex nut onto the hex head screw. Repeat this process for the remaining hole. NOTE: Do not completely tighten mounting hardware at this time.
11.Attach the lower dust bag retaining clip (A) Fig. 14A, to the dust collector drum. Align the two holes (B) in the retaining clip (A) Fig. 14A, with the two holes in the drum. Insert a 1/4-20x5/8" hex head screw through the holes in the retaining clip and the holes in the drum. Place a 1/4" flat washer onto the screws, and thread 1/4-20 hex nut on the screws and tighten securely. Repeat this process for the three remaining sides of the drum.
B
A
Fig. 14A
V