Bostitch 102272REVB 3/97 manual Loading the T40M Tools, Fastener Specifications

LOADING THE T40M TOOLS

1. Move pusher to rear until latched.

2.Use stick of staples to move cover spring to one side and drop over core of magazine.

Repeat until magazine is loaded, allowing enough space for pusher to disengage from the latch.

3.Depress pusher latch pin with thumb and allow pusher to slide forward to engage staples. On narrow crown models pull pusher back out of notch and allow to slide forward.

NOTE: Use only staples recommended by Stanley-Bostitch for the T40 Series staplers or staples which meet Stanley-Bostitch specifications.

FASTENER SPECIFICATIONS

STAPLE TYPE	STAPLE SERIES	TOOL MODEL	CROWN	WIRE SIZE	MAXIMUM LEG LENGTH
Wide Crown	S2-16 Ga.	T40S2	1.000 (25mm)	.0625 (1.58mm)	1-1/2” (38mm)
	S4-16 Ga.	T40S4	1/2” (13mm)	.0625 (1.58mm)	1-1/2” (38mm)
Narrow	S5-17 Ga.	T40S5	7/16” (11mm)	.054 (1.37mm)	1-1/2” (38mm)
Crown	SX5035	T40SX	5/32” (4mm)	.050x.035 (1.3x0.89mm)	1-1/4” (32mm)
	S5-17 Ga.	T40S5-SF	7/16” (11mm)	.054 (1.37mm)	1/2” (13mm)

•S2 & S4 Staples: 50 staples per stick; 3 sticks per load

•S5 Staples: 56 staples per stick; 3 sticks per load

•SX Staples: 100 staples per stick; 2 sticks per load

•All staples are galvanized finish.

-10-