Bostitch SW9040 5/8 SW9040 3/4 SW9040 7/8 manual D16-2AD

D16-2AD

BOXLOK STAPLER

STAPLE SIZES:	SW7437	7/16	SW7437 5/8	SW7437 3/4
	SW9040	5/8	SW9040 3/4	SW9040 7/8

OPERATION and MAINTENANCE MANUAL

BEFORE OPERATING THIS TOOL, ALL OPERATORS SHOULD STUDY THIS MANUAL TO UNDERSTAND AND FOLLOW THE SAFETY WARNINGS AND INSTRUCTIONS. KEEP THESE INSTRUCTIONS WITH THE TOOL FOR FUTURE REFERENCE. IF YOU HAVE ANY QUESTIONS, CONTACT YOUR BOSTITCH REPRESENTATIVE OR DISTRIBUTOR.

DO NOT USE SUPPLY SOURCES WHICH CAN POTENTIALLY EXCEED 80 PSIG (5.7 KG/CM2) AS TOOL MAY BURST, POSSIBLY CAUSING INJURY.

WHEN AIR SUPPLY .IS CONNECTED KEEP HANDS AND BODY AWAY FROM STAPLE DISCHARGE AREA AT ALL TIMES. DO NOT FIRE THE TOOL WITHOUT STAPLING INTO MATERIAL.

THE CONNECTOR ON THE TOOL MUST NOT HOLD PRESSURE WHEN AIR SUPPLY IS DISCONNECTED. IF A WRONG FITTING IS USED, THE TOOL CAN REMAIN CHARGED WITH AIR AFTER DISCONNECTING AND THUS WILL BE ABLE TO DRIVE A STAPLE EVEN AFTER THE AIR LINE IS DISCONNECTED POSSIBLY CAUSING INJURY.

DO NOT PULL TRIGGER OR DEPRESS CONTACT ARM WHILE CONNECTED TO THE AIR SUPPLY AS THE TOOL MAY CYCLE, POSSIBLY CAUSING INJURY.

DO NOT USE OXYGEN, COMBUSTIBLE GASES, OR BOTTLED GASES AS A POWER SOURCE FOR THIS TOOL AS TOOL MAY EXPLODE, POSSIBLY CAUSING INJURY.

FAILURE TO OBSERVE ANY OF THESE WARNINGS MAY RESULT IN INJURY.

BSA981SREVE 9/03 Stanley Fastening Systems