CLEANING & LUBRICATION
CleaningLubricating
Use
Do not allow dust, chips, sand, etc. into the air connectors or into the body of the nailer/stapler; this may result in leaks and damage to the nailer and the air cou- plings.
Never clean this tool with gasoline or other flammable liquids. Vapors in the tool may ignite, causing the tool to explode. Ignoring this warning may lead to serious personal injury or even death!
Standard pneumatic tool oil has been included with your new Grizzly nailer/sta- pler to help maintain its useful life. Place two to six drops of oil in the tool air inlet (as shown in Figure 9) before every use, or after 2 hours of continuous use.
Wipe off any excess oil near the exhaust port to avoid dust
Another option to manual oiling would be to install a lubricator in your air compres- sor line. If your air compressor line already has a lubricator, then regular lubrication of your nailer will not be necessary. Just make sure there is always oil in the lubri- cator.
Figure 9. Lubricating nailer/stapler via air
inlet.
Model H8236 |