OPERATIONS
Loading
When replacing staples in your Model H7678, follow these guidelines:
Gauge: 18
Length:
Capacity: 100
Crown: 1⁄4 "
To load your stapler:
1.DISCONNECT STAPLER FROM THE AIR SUPPLY!
2.Grip the stapler firmly, unlock the catch lever (Figure 3) and pull the magazine pusher back.
Pusher
Catch Lever
Figure 3. Unlocking catch lever.
3.Point the stapler up and insert a stick of staples, pointed-end up, into the bottom of the magazine, as shown in Figure 4. Make sure that the pointed ends of the staples point in the same direction as the stapler nose piece.
Pusher
Magazine
Figure 4. Loading staples into magazine.
4.Slide the staples all the way down to the nose of the stapler.
5.Slide the magazine pusher toward the nose of the stapler until the catch lever locks.
Operating
If you have not read the safety instruc- tions in this manual, do not operate the stapler.
Before you operate your stapler, place two to three drops of the included pneumatic tool oil into the quick connect fitting where the stapler connects to the air supply.
To operate your stapler:
1.Connect the air supply to the quick connect fitting.
2.To test for proper staple penetration, hold the stapler perpendicular to the surface of a piece of clean scrap wood that is thick enough for the length of staples you have loaded.
H7678 18 Gauge Deep Stapler Kit |