Grizzly H7678 instruction manual Clearing Jammed Staples

Page 12

Clearing Jammed

Staples

A jammed staple must be cleared before using the stapler again.

To clear a jammed staple from the dis- charge area:

1.DISCONNECT STAPLER FROM THE AIR SUPPLY!

2.Unlock the catch lever and slide the magazine pusher all the way back.

3.Remove the staple stick from the mag- azine.

4.Flip the quick release latch as shown in Figure 6 and open the cover.

Cover

Discharge

Area

Quick

Release

Latch

Figure 6. Area to remove jammed staple.

5.The jammed staple should now be vis- ible; remove it from the discharge area with needle nose pliers.

6.Secure the quick release latch.

7.Inspect the staple stick. If it is bent or damaged, throw it away and insert a new stick that only contains clean, undamaged staples. DO NOT use dirty or damaged staples!

8.Slide the magazine forward until the catch lever engages.

-10-

H7678 18 Gauge Deep Stapler Kit

Image 12
Contents Gauge Deep Stapler KIT Safety Safety Instructions For Pneumatic ToolsBefore Operating This Equipment H7678 18 Gauge Deep Stapler Kit Additional Safety Instructions for Staplers H7678 18 Gauge Deep Stapler Kit Introduction ForewordContact Info SET UP UnpackingInventoryCompressed Air System Safety Yoke Disconnect Stapler from the AIR SupplyOperations LoadingOperating Page Clearing Jammed Staples Replacing Pistons/O Rings Cleaning & Lubrication CleaningLubricatingH7678 Parts Breakdown H7678 Parts List DescriptionTroubleshooting Symptom Possible Cause SolutionWarranty and Returns Warranty Card Place Stamp Here