Grizzly H7947 Operations, Loading Staples, Unloading Staples, To load staples in your stapler

Page 10

OPERATIONS

Loading Staples

Use staples meeting the specifications listed for your stapler on Page 4 of this manual.

To load staples in your stapler:

1.DISCONNECT STAPLER FROM THE AIR SUPPLY!

Point the stapler away from you and others when connecting the air supply. The stapler can cycle and discharge a staple when the air supply is connect- ed. Ignoring this warning may result in serious personal injury.

2.Slide the magazine pusher to the rear of the magazine and pivot the pusher down until it catches in the lock notch on the magazine as shown in Figure 3.

Figure 3. Locking the pusher.

3.With the pusher locked at the rear of the magazine, insert a strip of staples into the magazine as shown in Figure 4.

Figure 4. Loading a staple strip into the

magazine.

4.Lift the pusher out of the lock notch and guide it forward to push the staple strip to the nose of the stapler.

Unloading Staples

To remove unused staples:

1.DISCONNECT STAPLER FROM THE AIR SUPPLY!

2.Point the stapler away from you and all bystanders.

3.Slide the pusher to the rear of the mag- azine and latch it into the lock notch.

4.Move the staples back from the nose and lift them up and out of the maga- zine.

-8-

H7947/H7948 16 Gauge Stapler

Image 10
Contents Model H7947/H7948 Before Operating This Equipment SafetySafety Instructions For Pneumatic Tools Mation about proper operation of the equipmentAlways Wear Ansi Approved Hearing Protection Additional Safety Instructions for Staplers H7947/H7948 16 Gauge Stapler Introduction Foreword Model H7948 SpecificationsModel H7947 Specifications Contact InfoUnpackingInventory SetupModel H7947/H7948 Figure Compressed Air System Testing Safety Nose Mechanism To verify that the safety nose is working correctlyUnloading Staples OperationsLoading Staples To load staples in your staplerUsing the Stapler To operate your staplerAdjusting Depth To adjust the depthClearing Jammed Staples To clear a jammed staple from the dis- charge areaReplacing Pistons/O-Rings To replace a piston and O-ringsCleaning & Lubricating CleaningLubricatingH7947 Parts Breakdown H7947 Parts List DescriptionH7948 Parts Breakdown H7948 Parts List Troubleshooting Symptom Possible Cause SolutionWarranty and Returns Page Warranty Card Name Street CityStateZip BOX BELLINGHAM, WA