Grizzly H7947, H7948 instruction manual Compressed Air System

Page 8

Compressed Air

System

The Model H7947/H7948 is designed to be operated at 70–110 PSI using clean, dry, regulated, compressed air. DO NOT exceed 120 PSI.

An in-line filter/lubricator/regulator unit, depicted in Figure 2, can be installed and should be located as close to the stapler as possible.

This filter/lubricator/regulator unit will pro- tect your tool from damaging water build- up, allow you to adjust and maintain con- stant air pressure to your tool, and save you the inconvenience of manually lubri- cating your tool every time you use it.

Check the current Grizzly catalog for avail- ability of this unit. If you plan on install- ing a filter/lubricator/regulator unit in your compressed air system, always follow the connection instructions that come with the unit.

Exceeding the maximum permissible operating pressure may damage the seals, gaskets and hammer mecha- nism of your stapler. DO NOT allow your air compressor to exceed the recommended pressure when con- nected to this stapler or serious per- sonal injury may result!

Quick

Quick

Lubricator

Connector

Connector

Regulator

Your

 

 

Air

Tool

 

 

Compressor

Quick

 

 

 

Coupler

 

Quick

 

 

Air Hose

Filter

 

Coupler

 

 

Figure 2. Typical filter/lubricator/regulator installation order.

-6-

H7947/H7948 16 Gauge Stapler

Image 8
Contents Model H7947/H7948 Safety Safety Instructions For Pneumatic ToolsBefore Operating This Equipment Mation about proper operation of the equipmentAlways Wear Ansi Approved Hearing Protection Additional Safety Instructions for Staplers H7947/H7948 16 Gauge Stapler Foreword Model H7948 Specifications Model H7947 SpecificationsIntroduction Contact InfoModel H7947/H7948 Figure SetupUnpackingInventory Compressed Air System Testing Safety Nose Mechanism To verify that the safety nose is working correctlyOperations Loading StaplesUnloading Staples To load staples in your staplerUsing the Stapler To operate your staplerAdjusting Depth To adjust the depthClearing Jammed Staples To clear a jammed staple from the dis- charge areaReplacing Pistons/O-Rings To replace a piston and O-ringsCleaning & Lubricating CleaningLubricatingH7947 Parts Breakdown H7947 Parts List DescriptionH7948 Parts Breakdown H7948 Parts List Troubleshooting Symptom Possible Cause SolutionWarranty and Returns Page Warranty Card Name Street CityStateZip BOX BELLINGHAM, WA