Driving staples
Place the tool on the material to be fastened so that the front and the rear of the tool contact the material flat. Do not tip the tool to the right or left side. Hold the tool firmly against the material, Then pull the trigger to drive the staples.
If the staples are driven too shallow, press the tool head as shown in the figure and drive the staples.
If the staples are s t i l l driven too shallow, adjust the driving depth by turning the nut clockwise. Refer to "Depth adjustment".
CAUTION :
Do not operate the tool without staples. It shortens the service life of the tool.
If the tool becomes jammed, do as follows. First, remove the battery cartridge. Open the
Sight window
There is a convenient sight window on the tool side. Use this sight window to check if there are staples in the magazine. When staples are not visible through the window, load staples into the magazine.
Staples
0 Handle the staples and their box carefully. If the staples have been handled roughly, they may be bent out of shape, causing poor staple feed or jamming.
.Avoid storing the staples in a very humid or hot place or place exposed to direct sun- light.
0 Do not attempt to use staples that appear to be damaged, bent, rusty or corroded.
10