Safety system

Make sure all safety systems are in working order before operation. The tool must not operate if only the trigger is pulled or if only the safety lever is pressed against the wood. It must work only when both actions are performed. Test for possible faulty operation with a tool unloaded and pointed well away from yourself or any bystanders.

NOTE :

There is a possibility that the tool may operate for an instant when only the trigger is pulled. This does not indicate a problem. If this occurs, point the tool well away from yourself or any bystanders. Release and pull the trigger again to make sure the safety systems are in working order.

Loading staples

CAUTION:

Always remove the battery cartridge before loading the staples into the tool.

Press the plate spring on the rear of the sub-magazine and slide the sub-magazine

backward.

Plate spring

Load staples into the main magazine with staple ends facing up as illustrated a t right.