Makita T221D instruction manual If the staples are driven too deep or too

To secure the sub-magazine in place, push the sub-magazine while pressing the plate spring on the rear of the sub-magazine.

CAUTION :

0 Always secure the sub-magazinein place, or the staples can drop out and cause problems.

With the magazine loaded, if the tool is held downward and the sub-magazinei s opened, the staples can fall out and present a danger to anyone or anything below. Keep this in mind especially when working in high locations.

Depth adjustment	I
If the staples are driven too deep or too
shallow, adjust the driving depth by turn-	I
ing the nut on the bottom of the tool. For
deeper driving of staples, turn the nut
clockwise. For shallower driving, turn the
nut counterclockwise. Please note the nut
must be turned in increments of 180" (1/2
turn) so that the groove on the nut runs
parallel to the magazine.

NOTE :

If the distance between the tool end (A) and the material to be fastened is more

than 2 mm ( 5 / 6 4 " ) , the tool will not operate because the safety lever is not pressed enough to operate the tool.

hlllf

i

9