908991 -
EMPLOYER’S RESPONSIBILITIES
Employer must enforce compliance with the safety warnings and all other instructions contained in this manual.
Keep this manual available for use by all people assigned to use this tool.
For personal safety and proper operation of this tool, read and understand tool labels and manual. Failure to follow warnings could result in DEATH or SERIOUS INJURY. Read and follow all of these instructions carefully.
FUNCTIONAL DESCRIPTION
FOREWORD
Use approved
POWER SOURCE
This tool is designed to operate on clean, dry, compressed air at regulated pressures between 70 and 120 PSI (Pounds per Square Inch)(4.8 to 8.3 BAR). The preferred system would include a filter, a pressure regulator, and an automatic oiler located as close to the tool as possible, within 15 ft/4.6 m is ideal.
All compressed air contains moisture and other contaminates that are detrimental to internal components of the tool. An air line filter will remove most of these contaminates and significantly prolong the life of the tool. If an
The tool is equipped with a 1/4" male “quick connector”. A 3/8" male “quick connector” is available from
All air line components (hoses, connectors, filters, regulators, etc.) must have a minimum working pressure rating of at least 150 PSI (10.3 BAR) or 150% of maximum system potential, whichever is greater.
Do not connect tool to pressure which potentially exceeds 200 PSI (13.7 BAR).
Only connect tool to air supply hose with a coupling that automatically removes all pressure from the tool when the coupling is disconnected.
Disconnect tool from air supply before performing maintenance, clearing a jammed fastener, leaving work area, moving tool to another location, or handing the tool to another person.
PREPARING THE TOOL
1.After reading and understanding this entire manual, connect tool to
air supply (Fig. 18).
Never point tool at yourself or others.
Always connect tool to air supply before loading fasteners (Fig. 18). Do not load fasteners with trigger or safety depressed.
7