ATTACHING TOOL
TO STAND
1.Use a helper to lift and position the tool and top shelf (A) Fig. 8 on the four legs (B).
2.Fasten the top shelf to the six top holes in the legs (four of which are shown). Insert the six 5/8" carriage bolts (C), then attach the flat washers, and hex nuts.
3.Tighten all stand mounting hardware, starting with the bottom nuts.
ATTACHING
SANDING DISC
CAUTION: DISCONNECT TOOL FROM POWER SOURCE.
1.Clean the sanding disc plate (A) Fig. 9 of any oil or grease, and be certain that it is dry.
2.Peel approximately 1/2 of the backing (B) Fig. 9 from the sanding disc (C).
3.Insert the sanding disc (C) with the paper backing downward between the disc assembly and the disc guard (Fig. 9).
4.Press the top half of the sanding disc firmly against the disc assembly (Fig. 9B).
5.Manually rotate the disc assembly and remove the paper from the sanding disc (Fig. 9C). Press the remaining half of the sanding disc firmly against the disc assembly.
6.IMPORTANT: SECURELY POSITION THE SANDING DISC ON THE DISC ASSEMBLY PRIOR TO APPLYING POWER TO THE TOOL.
ATTACHING
DISC TABLE
Attach the disc table (A) Fig. 10 to the two trunnions using the four 1" hex socket cap screws (B).
NOTE: Maintain a maximum distance of 1/16" between the sanding belt and the table.
B 
A
Fig. 10
A
C
C
B
Fig. 8
BA
C
Fig. 9
Fig. 9B
Fig. 9C
7