Delta 31-280 instruction manual Attaching Dust Chute, Moving Sanding ARM to the Vertical Position

ATTACHING DUST CHUTE

Attach the dust chute (A) Fig. 11 to the bottom of the top shelf (B) using the four 5/8" self-tapping screws.

MOVING SANDING ARM TO THE VERTICAL POSITION

The sanding arm is shipped in the horizontal position (Fig.

12). To move the arm to the vertical position:

1.Loosen the lock handle (A) Fig. 12. NOTE: Lock handle is spring-loaded and can be repositioned by pulling out the handle, moving it, and letting it spring back into position.

2.Move the sanding arm (B) to the vertical position (Fig. 13) and tighten the lock handle (A).

A

Fig. 12

A

B

Fig. 11

B

A

Fig. 13

OPERATING CONTROLS AND ADJUSTMENTS

STARTING AND STOPPING THE TOOL

The on-off switch (A) Fig. 14 is located on the sander base. To turn the sander “ON”, move the switch to the up position. To turn the sander “OFF”, move the switch to the down position.

LOCKING SWITCH IN THE “OFF” POSITION

IMPORTANT: When the tool is not in use, the switch should be locked in the “OFF” position to prevent unauthorized use, using a padlock (A) Fig. 15 with a 3/16" diameter shackle.

A

A

Fig. 14 Fig. 15

8