Emptying the Collector Bag
CAUTION
Wearing a particle mask/respirator for
protection against fine dust particles during
cleaning is highly recommended.
During first use and after cleaning, the bag may allow some dust to escape. This is normal and will stop after a short period of time.
Clean the collector bag frequently to keep the collector's performance at its optimum. To clean:
1.Disconnect the machine from the power source, unplug.
2.Remove the collector bag from the hanger rods.
3.Loosen the ring clamp and remove the bag.
4.Empty the contents into an appropriate container. The bag is easily emptied by unzipping the bottom of the bag.
Optional Accessories
57620025: JET Stik Abrasive Belt and Disc Cleaner.
“J” Weight Cloth Back.
12” | 36 Grit | 50 Grit | 60 Grit | |
Stock | 57698525 | 57698650 | 57698750 | |
Number | ||||
|
|
| ||
Master | 25 | 50 | 50 | |
Carton | ||||
|
|
| ||
12” | 80 Grit | 100 Grit | 120 Grit | |
Stock | 57698850 | 57698950 | 57699050 | |
Number | ||||
|
|
| ||
Master | 50 | 50 | 50 | |
Carton | ||||
|
|
|
Troubleshooting
Trouble |
| Possible Cause |
| Solution | |
|
|
|
|
| |
| 1. | Sander unplugged from wall | 1. Check all plug connections | ||
|
| or motor | |||
|
|
|
| ||
Sander will not start | 2. | Fuse blown or circuit breaker | 2. Replace fuse or reset circuit | ||
| breaker | ||||
|
| tripped |
| ||
|
|
|
| ||
| 3. | Cord damaged | 3. | Replace cord | |
|
|
| |||
|
|
|
| ||
| 1. | Extension cord too light or | 1. Replace with adequate size | ||
Sanding disc does not come |
| and length cord | |||
| too long |
| |||
up to speed |
|
|
| ||
2. | Low current | 2. | Contact a qualified | ||
| |||||
|
| electrician | |||
|
|
|
| ||
|
|
|
| ||
| 1. | Stand or base on uneven | 1. Adjust stand or base so that | ||
Machine vibrates excessively |
| it rests evenly on the floor | |||
|
| surface | 2. | Bolt down | |
|
|
| |||
|
|
|
|
| |
Sanded edge not square | 1. | Table not square to sanding | 1. | Use a square to adjust table | |
| disc |
| to sanding disc | ||
|
|
| |||
|
|
|
|
| |
| 1. | Work held still | 1. | Keep workpiece moving | |
| 2. Use coarser grit for stock | ||||
|
|
| |||
Sanding marks on wood | 2. | Wrong grit sanding disc |
| removal and fine grit for | |
3. | Feed pressure too great |
| finish sanding. | ||
|
| ||||
| 3. | Never force workpiece | |||
| 4. | Sanding against the grain | |||
| 4. Sand with the grain | ||||
|
|
| |||
|
|
|
|
| |
12