Collector Bag Assembly, Table Adjustment

Collector Bag Assembly

1.Mount the inlet port (A, Fig. 4) to the cabinet with four M6x12 pan head screws (B, Fig. 4).

2.Thread two M6 nuts (C, Fig. 4) on the shaft of hanger rods (D, Fig. 4). Thread rods into the cabinet and tighten nuts against the cabinet.

3.Place the loops (E, Fig. 4) of the collector bag onto the hanger rods.

4.Loosen ring clamp (F, Fig. 4) all the way and place on the inlet port. Fit collector bag opening onto inlet port, and secure in place by tightening the ring clamp.

Table Adjustment

The table stops have been set-up at the factory. However, if you run into a problem, or want to check the table follow the below listed steps.

1.Loosen knobs (G, Fig. 5) and move table into the 90-degree position. Tighten knobs and place a square (H, Fig. 5) against the table and sander disc. The square should rest flat against the table and the disc.

2.If adjustment is needed move the table so that it rests 90 degrees from the table, and loosen the hex nut (I, Fig. 5) and tighten the set screw (J, Fig. 5) until it contacts the table surface. Tighten hex nut. This will properly adjust the 90-degree stop.

3.Loosen knobs (G Fig. 5) and tilt table up enough to pivot the stop (K, Fig. 5) out of the way.

4.Tilt the table down until it hits the 45-degree stop (L, Fig. 5). Tighten the lock knobs, and check the table with a combination square.

5.If adjustments needed, loosen hex nut (M, Fig. 5) and adjust socket head screw (L, Fig.

5)until it contacts table. Tighten hex nut.

6.Always maintain a gap of approximately 1/16” between the table edge, and disc. If adjustment is necessary loosen hex cap bolts (N, Fig. 6) and move the table into position. Tighten hex cap bolts.

7.The table can be tilted between 15° up - 45° down by loosening lock knobs and tilting the table to the desired angle. Tighten knobs.

8.If you want to tilt the table up you need to pivot the stop (E, Fig. 5) out of the way.