Heath Zenith SL-5660 instruction

Model SL-5660

High Pressure Sodium Dusk- to-Dawn Security Light

Installation Instructions

READ ALL INSTRUCTIONS CAREFULLY BEFORE BEGINNING INSTALLATION.

NOTE: All wiring must be run in accordance with the National Electrical Code (Canadian Electrical Code in Canada) through conduit or another acceptable means. Contact a qualiﬁed electrician if there is any question as to the suitability of the system.

Photocontrol

Lens/Reﬂector

Assembly

Ground

Screw

Cover Plate

Fixture wires thru

this hole

Lamp in Fixture Contains Mercury. Dispose According to Local, State, or Federal Laws.

WARNING: Turn power off at the fuse or circuit breaker.

1.Select a location on a ﬂat wall with structurally sound wood and from 10 to 25 feet (3 to 7.6 m) from the ground. The wood should be at least one inch (25 mm)thick to safely secure the ﬁxture.

2.Using the mounting template as a guide, mark the 3 mounting holes. We suggest drilling 3/16" (4.8 mm) pilot holes for the lag screws.

3.Install the two bottom lag screws ﬁrst. Screw in the lag screws so that there is about 3/8" (9.5 mm) of space under the head.

4.Place the ﬁxture on these two screws and install the top lag screw. Tighten the top lag screw ﬁrst, then tighten the remaining lag screws.

5.Secure your outdoor cable or ﬂexible conduit to the cover plate with a ﬁtting in accordance with the National Electrical Code.

6.Thread the black and white ﬁxture wires through the hole in the cover plate as shown.

7.Connect the ﬁxture wires to the service wires (black to black and white to white).

8.This ﬁxture must be connected to ground. Secure the service ground wire under the head of the green ground screw.

9.Install the cover plate. Secure with the two screws and nuts provided.

10.Install the reﬂector/lens assembly. Secure with the two screws and washers provided.

11.Screw in the 70 watt H.P. Sodium type S62 lamp provided.

12.Loosen the screw in the center of the photocontrol socket two turns. Twist the socket so that the arrow points north. Note: There is a stop to prevent the socket from turning all the way around. If you have trouble turning the socket, try turning it the other direc- tion. Retighten the screw in the center of the socket.

13.Align the photocontrol (it will only plug-in one way). Plug it in and twist clockwise until it stops.

To test operation during daylight, cover the photocontrol with a small box. Turn on the power. Not all photocontrols are alike. Some may have a time delay of a few minutes, others will turn on as soon as power is applied. The light will take up to ten minutes to reach full brightness. Uncover the photocontrol and your unit will operate automatically—on at dusk, off at dawn.

598-1089-03