The sensor is less sensitive to motion directly towards it and more sensitive to motion across coverage area.
MotionMotion
| Sensor |
|
| |
Least Sensitive | Most Sensitive | |||
| OPERATION |
| ||
|
|
|
|
|
Mode: |
| Works: Day | Night | |
Test | 5 Seconds |
| x | x |
Auto | 1, 5, or 10 |
|
| x |
| Minutes |
|
|
|
Manual | To Dawn* |
|
| x |
* resets to Auto Mode at dawn.
Note: When firstturned on wait about 1 1/2 minutes for the circuitry to calibrate.
MANUAL MODE
Mode Switching Summary
| TEST |
|
|
| ||
|
|
| ||||
|
|
|
|
| ||
|
|
|
|
| minutes | |
| AUTO |
|
|
|
| Fliplightswitchoffforone |
|
|
|
|
|
| |
|
|
|
|
|
| second then back on* |
MANUAL MODE |
|
|
| |||
|
| |||||
*If you get confused while switching modes, turn the power off for one minute, then back on. After the calibration time the control will be in the AUTO mode.
Adjustment of Coverage Area
The sensor on this light fixture detects “motion” by the movement of heat across the coverage area. However, following are examples of objects that also produce heat and can cause the sensor to trigger:
• Pools of Water | • Air Conditioners |
• Dryer Vents | • Animals |
• Heating Vents | • Automobile Traffic |
If you suspect that a heat source of this type is triggering the sensor, reduce the sensitivity.
| SPECIFICATIONS |
Range | ................................Up to 30 ft.(9.1 m) [varies with |
| surrounding temperature]. |
Manual mode only works at night because daylight returns the sensor to AUTO.
Flip the light switch off for one sec- ond then back on to toggle between AUTO and MANUAL MODE.
Manual mode works only with the
1 Second OFF
then...
Sensing Angle | 180° |
Electrical Load | Up to 100 Watt Maximum |
| Tungsten Incandescent |
Bulb Type | Medium Base, Type “A”, 100 |
| Watt Maximum |
Sensor Capacity | 360 Watt (3.0 A) Maximum |
| Tungsten Incandescent |
Power Requirements | 120 VAC, 60 Hz |
Operating Modes | TEST, AUTO, and MANU- |
| AL MODE |
1, 5, 10 minutes |
... back on.
Test Timer | 5 Seconds |
Manual Mode Timer |