READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING LUMINAIRE |
|
| INSTRUCTION SHEET NO. |
| ||||
|
|
|
|
|
|
| ||
This luminaire is intended for installation in accordance with the National Electrical Code and local regulations. |
|
|
| IS: C3MR |
|
| ||
To assure full compliance with local codes and regulations, check with your local electrical inspector before |
|
|
|
|
| |||
installation. To prevent electric shock, turn off electricity at fuse box before proceeding. |
|
|
|
|
| |||
Retain these instructions for maintenance reference. |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
|
|
| B0206 |
| Page 1 of 2 |
| ||
|
|
|
|
|
| |||
INSTALLATION PROCEDURE FOR CALCULITE→ EVOLUTION TRIMS
WARNING: USE ONLY REFLECTOR TRIMS PROVIDED BY LIGHTOLIER. USE OF OTHER MANUFACTURER’S
REFLECTOR TRIMS MAY VOID THE UNDERWRITERS LABORATORIES LISTING AND COULD CONSTITUTE A FIRE HAZARD.
1.MAKE SURE THAT POWER TO THE LUMINAIRE IS OFF.
2.Select proper LAMP for application.
3.Remove TRIM FACEPLATE from TRIM BODY by compressing TORSION SPRING. Fig. 1
4.Insert LAMP between LAMP SPRINGS of LAMP HOLDER ASSEMBLY until face of LAMP sits firmly on GLASS LAMP GUARD. Fig. 2
CAUTION! RISK OF FIRE. GLASS LAMP GUARD MUST BE INSTALLED. Lamp manufacturers require the glass lampguard be in place before energizing lamp, and that great care must be taken that lamp is fully cooled before re- lamping. Avoid finger marks on the inside of the lamp, as it may shorten lamp life or cause breakage.
5.Insert LAMP HOLDER ASSEMBLY into TRIM BODY until LAMP SPRINGS snap into place. Fig. 3
6.Bring TRIM BODY to FRAME and attach SOCKET to
Prior to installing your LIGHTOLIER TRIM, the horizontal rotation can be preset within the luminaire. Note the BEAM CENTERING NOTCH Fig.4 allows the installer to predetermine the direction the lamp will point to illuminate a wall or object of interest (not applicable to downlight trims). Once the notch is aligned with the object of interest, simply tighten the ROTATIONAL BRAKE SCREW until the spring is fully compressed Fig. 5.
7.Ensure the two SECURING CLIPS are in the disengaged position.Fig.1 on pg. 2. Align the two THICK CEILING READY BRACKETS with the SECURING CLIPS and insert TRIM BODY up until the bottom of TRIM BODY is flush or slightly recessed from bottom of ceiling plane. Properly engage SECURING CLIPS by pushing them into THICK CEILING READY BRACKETS. Fig’s 2 & 3 on pg. 2
Fig. 1
Trim Body
Torsion Spring 
Trim Faceplate 
|
|
|
|
|
| Lamp |
|
| Fig. 2 |
|
|
|
| Lamp Springs |
|
|
|
| |
|
|
| ||
Lamp Holder |
|
| ||
Assembly |
|
| ||
|
|
| ||
|
|
| ||
Lamp Removal |
|
| ||
Spring |
|
| ||
|
|
|
|
|
Fig. 3
Socket
Thick Ceiling
Ready Brackets
Rotational Fig. 5
Brake Screw
| Beam |
| Centering |
Fig. 4 | Notch |
| |
|
|
U.S. AND FOREIGN PATENTS PENDING
A 
COMPANY
631 Airport Road, Fall River, MA 02720