Multiquip MVH406GH manual Traveling

MVH-406GH — OPERATION

3.Place the choke lever ( Figure 17) in the “OPEN” position if starting a cold engine.

Figure 17. Engine Choke Lever (Open)

4.Place the choke lever ( Figure 18) in the “CLOSED” position if starting a warm engine or if the temperature is warm.

Figure 20. Engine Start Handle

7.If the engine has started, slowly return the choke lever (Figure 18) to the “CLOSED” position. If the engine does not start, repeat steps 1 through 6.

8.Before the compactor is placed into operation, run the engine for several minutes. Check for fuel leaks and noises that would be associated with a loose component.

Figure 18. Engine Choke Lever (Closed)

5.Place the engine ON/OFF switch (Figure 19) in the “ON” position.

Figure 19. Engine ON/OFF Switch (ON position)

TRAVELING

CAUTION

Make sure to follow all safety rules referenced in the safety section of this manual before operating compactor. Keep work area clear of debris and other objects that could cause damage to the compactor or bodily harm.

1.Grasp the compactor's hand grip (Figure 21), and move the engine throttle lever (Figure 21) quickly to the fast position.

2.With the throttle lever in the fast position, the engine speed should be around 3,600 RPM, therefore engaging the cen- trifugal clutch

6. Grasp the starter grip (Figure 20) and slowly pull it out.The	Figure 21. Throttle Lever (Fast)
resistance becomes the hardest at a certain position,
corresponding to the compression point. Pull the starter
briskly and smoothly for starting.

MVH406GH PLATE COMPACTOR — OPERATION AND PARTS MANUAL — REV. #3 (02/04/14) — PAGE 19