Powermatic 60B operating instructions Table Removal

IMPORTANT: If the bearings need replacement, this should be done by qualified service personnel. The bearings are press fitted and must be removed with an arbor press.

To re-install cutterhead, reverse the above procedure. Before re-installing, make sure the machine's curved seats of the base casting are free of dirt, dust or grease, to help ensure a tight fit.

NOTE: Whenever the cutterhead is re-installed on the jointer, the tables must be leveled in relationship to it.

You may wish to keep an extra cutterhead on hand to maintain shop productivity.

Table Removal

1.Disconnect jointer from power source.

2.Remove fence assembly except for the support casting.

3.Remove cutter guard.

4.Lower infeed and outfeed tables and remove cutterhead.

5.Loosen the gib set screws and table lock screws.

After gib screws are loosened, table could suddenly slide down.

6.Remove infeed or outfeed table by sliding upward.

23