Porter-Cable 557 instruction manual Surface T Joints, Are completed

Page 17

7.Hold tool firmly as shown in Fig. 21, squeeze trigger switch to start tool.

8.At a slow, steady pace, push tool forward in base as far as depth stop allows.

9.Release trigger switch to stop tool and remove tool from work.

10.Repeat steps 6 through 9 until all the grooves for this joint

are completed.

Fig. 21

NOTE: Assemble all joints and verify alignments before applying glue (see Fig. 22).

Fig. 22

SURFACE (“T”) JOINTS

1.Layout groove positions as described in POSITIONING GROOVES.

2.Set depth stop turret to desired biscuit (or other accessory), size.

3.Mark centerline of joint on workpiece “A” (see Fig. 23).

4.Clamp a straight edge guide to the workpiece, 3/8" back from the joint centerline (as marked in Step 2). Clamp workpiece securely (see Fig.

24).

5.Set tilt fence to 0° position (see Angle Adjustment Section of this manual).

6.Position tool to workpiece with bottom of base against straight edge and guide notch (C) Fig. 25, aligned with a groove centerline. Apply pressure to auxiliary handle (D) Fig. 25 to hold tool firmly in place.

7.Hold tool firmly as shown in Fig. 21. Squeeze trigger switch to start tool.

A

B

Fig. 23

3/8"

Fig. 24

17

Image 17
Contents Double Insulated Plate Joiner Important Safety Instructions Table of ContentsCalifornia Proposition Safety Guidelines DefinitionsGeneral Safety Rules General Safety Rules Additional Specific Safety Rules Symbol Definition Extension Cord Selection Carton ContentsMotor Operation AssemblyFunctional Description Depth of Groove Adjusting Depth of GrooveFine Adjustment Height Adjustment see Figs Adjustable FenceBlades 2 Fine Adjustment 90 PositionDo not Operate Tool Without Blade Cover Installed Double Biscuits Disconnect Tool from Power SourceDust Port Dust/Chip Deflector NozzleDuplex Hinges Attaching Dust BAG#6 Biscuits Positioning GroovesPractice Cuts Height AdjustmentCorner Joints Positioning GroovesAre completed Surface T JointsGrooves Butt JointsMiter Joints Page Keep Tool Clean Troubleshooting MaintenanceFailure to Start LubricationReplacement Parts Service and Repairs ServiceAccessories PORTER-CABLE Limited ONE Year Warranty WarrantyArizona Georgia Minnesota Canadian PORTER-CABLE Delta Service Centers
Related manuals
Manual 23 pages 24.88 Kb