8.At a slow, steady pace, push tool forward in base as far as depth stop allows.
9.Release trigger switch to stop tool and remove tool from work.
10.Repeat steps 5 through 8 until all the grooves in workpiece “A” are completed.
11.Follow steps 3 through 10 of CORNER JOINTS Section to complete required grooves in workpiece “B” Fig. 23.
NOTE: Assemble all joints and verify alignments before applying glue (see Fig. 26).
C
D
Fig. 25 | Fig. 26 |
BUTT JOINTS
Tool adjustment and operation for producing butt joints (see Fig. 19), is the same as for CORNER JOINTS.
MITER JOINTS |
|
| C | |
1. | Layout groove positions as |
|
| |
|
|
| ||
| described in POSITIONING |
|
|
|
| GROOVES. |
|
|
|
2. | Set depth stop turret to |
|
|
|
| desired biscuit (or other |
|
|
|
| accessory), size. |
|
|
|
3. | Set the tilt fence to desired |
|
|
|
| angle (see Angle Adjustment |
|
|
|
| Section of this manual). |
| A | |
4. | Set fence height adjustment |
| ||
| to desired height (see Height |
|
|
|
| Adjustment Section of this |
|
|
|
| manual). |
|
|
|
5. | Clamp workpiece securely. | B | ||
|
|
6.Position tool to workpiece utilizing either guide notch
(A) or (B) Fig. 27, to align tool with a groove centerline.
Apply pressure to auxiliary handle (C) Fig. 27, to hold tool firmly in place.
18