001145 |
1 |
1. Limit mark
001716
1
2
1.Screwdriver
2.Brush holder cap
Replacing carbon brushes
Remove and check the carbon brushes regularly. Replace when they wear down to the limit mark. Keep the carbon brushes clean and free to slip in the holders. Both carbon brushes should be replaced at the same time. Use only iden- tical carbon brushes.
Use a screwdriver to remove the brush holder caps. Take out the worn carbon brushes, insert the new ones and secure the brush holder caps.
To maintain product SAFETY and RELIABILITY, repairs, any other maintenance or adjustment should be performed by Makita Authorized or Factory Service Centers, always using Makita replacement parts.
ACCESSORIES
CAUTION:
•These accessories or attachments are recommended for use with your Makita tool specified in this manual. The use of any other accessories or attachments might present a risk of injury to persons. Only use accessory or attachment for its stated purpose.
If you need any assistance for more details regarding these accessories, ask your local Makita service center.
•1/4” router bits
•Straight & groove forming bits
•Edge forming bits
•Laminate trimming bits
•Straight guide assembly
•Trimmer guide assembly
•Trimmer base assembly (For chamfering with straight bit)
•Trimmer shoe
•Templet guide
•Collet cone 1/4”
•Wrench 10
•Wrench 17
13