001704
2
3
1 
1
Loosen the screws and remove the base protector. Place the templet guide on the base and replace the base protector. Then secure the base protector by tightening the screws.
1.Screws
2.Base protector
3.Screwdriver
| 001705 | |
3 | 4 | |
1 | ||
| ||
2 |
| |
5 | 6 | |
| 7 |
1.Base
2.Templet
3.Straight bit
4.Templet guide 10
5.Distance (X)
6.Workpiece
7.10 mm (3/8”)
Secure the templet to the workpiece. Place the tool on the templet and move the tool with the templet guide sliding along the side of the templet.
NOTE:
The workpiece will be cut a slightly different size from the templet. Allow for the distance (X) between the router bit and the outside of the templet guide. The distance (X) can be calculated by using the following equation:
Distance (X) = (outside diameter of the templet guide - router bit diameter) / 2
001706 |
Straight guide (optional accessory)
The straight guide is effectively used for straight cuts when chamfering or grooving.
9