ASSEMBLY
NOTE:
•Use a dry cloth to wipe the dirt off the lens of light. Be careful not to scratch the lens of light, or it may lower the illumination.
CAUTION:
•Always be sure that the tool is switched off and unplugged before carrying out any work on the tool.
| 001700 | Installing or removing trimmer bit |
1 | 2 | CAUTION: |
| ||
|
|
• Do not tighten the collet nut without inserting a bit, or the collet cone will break.
• Use only the wrenches provided with the tool.
3Insert the bit all the way into the collet cone and tighten the
1. | Loosen | collet nut securely with the two wrenches. To remove the bit, |
2. | Tighten | follow the installation procedure in reverse. |
3. | Hold |
|
OPERATION | Set the tool base on the workpiece to be cut without the bit | |
making any contact. Then turn the tool on and wait until the bit attains full speed. Move the tool forward over the work- piece surface, keeping the tool base flush and advancing smoothly until the cutting is complete.
When doing edge cutting, the workpiece surface should be on the left side of the bit in the feed direction.
|
| 001701 |
|
| 6 |
1 | 3 | 7 |
|
| |
2 | 4 5 | 8 |
|
|
1. | Workpiece | 2. | Bit revolving direction |
3. | Feed direction | 4. | View from the top of the tool |
5. | Correct bit feed direction | 6. | Bit revolving direction |
7. | Feed direction | 8. | Correct bit feed direction |
7