Operating Heater
Continued
WARNING: Always operate manual control heaters at the locked positions. Operation between these positions may create a possible health hazard if used in a poorly ventilated room. Read owner’s manual for complete instructions.
CAUTION: Do not try to ad- just heating levels by using the equipment shutoff valve.
TO TURN OFF GAS
TO APPLIANCE
To Shut Off Heater:
1.Turn control knob clockwise to the OFF position.
2.Turn off all electric power to the appliance if service is to be performed.
MANUAL LIGHTING
PROCEDURE
1.Remove front panel (see Figure 6, page 9).
2.Follow steps 1 through 7 under Lighting Instructions, page 16.
3.With control knob pressed in, strike match. Hold match to pilot until pilot lights.
4.Keep control knob pressed in for 30 sec- onds after lighting pilot. After 30 seconds, release control knob. Now follow step 9, under Lighting Instructions, page 16.
5.Replace front panel.
Hand-Held Remote
Operation
The remote control transmits signals to receiver. This remote control system was developed to provide a safe, reliable and user friendly remote control system for gas heat- ing appliances. The system can be operated manually from the remote control. The system operates on one of 255 security codes on the remote control and receiver. Security codes can be set by the user.
IMPORTANT: The remote control will only operate heater if pilot light is lit and control knob is in the ON position.
Remote Control
The remote control has ON, OFF, THERMO- STAT, and PROGRAM functions. This is part of the system’s design. If the LCD screen is not working check the position of the remote control’s battery.
The remote control has two code switches located on the back that will need to be set when installation is complete, see Code Set- ting page 19.
The remote control operates on 2 AAA 1.5V size batteries (included) that powers the RF signal and LCD screen. Before using the remote control, batteries must be installed into the battery compartments. See Installing Batteries Into Remote, page 11.
|
| LCD |
| OFF | Display |
ROOM | SET |
|
PM |
|
|
|
| Mode |
DOWN | UP | Buttons |
TIME/PROGRAM | SET |
|
Front
Cover
Figure 24 - Remote Control
LCD Display
1.LOW - Battery power is low. Replace bat- teries within two weeks.
2.PROGRAM - Indicates when unit is functioning in one of the preset program settings.
3.MODE - Indicates operation MODE of system. ON indicates system is on either manually or thermostatically. OFF indi- cates entire system is turned off. THER- MO indicates system will automatically cycle on and off depending on program.
4.SET - Indicates desire set room tempera- ture for THERMO operation.
5.FLAME - Indicates burner and valve in operation.
6.CLOCK - Indicates current time in AM or PM.
7.ROOM - Indicates CURRENT room tem- perature.
8.°F indicates degrees Fahrenheit (°C indi- cates degrees Celsius).
16 | www.desatech.com |