Invacare Top End ForceTM, XLTPRO manual Installing/Removing/Adjusting the Road Crown Compensator

SECTION 8—SERVICE PROCEDURES

	Mounting Bolts
Crank Arm Clamp	and Locknuts	Chain	Right Crank Arm (Tabs)
		Ring Disk
Left Crank Arm
			Spindle, Socket
Spindle, Socket			Screw and Cap
Screw and Cap
			Crank Arm Clamp and
			Socket Screws
	Socket Screws

FIGURE 8.2 Replacing the Crank Arms - XLT Gold, XLT PRO and Top End Force

Installing/Removing/Adjusting the Road Crown Compensator

NOTE: For this procedure, refer to FIGURE 8.3 on page 51.

NOTE: The road crown compensator is designed to stabilize the handcycle during transfers and while riding and is not intended to keep the handcycle straight when pedaling but to keep the handcycle from leaning excessively to one side or another.

Installing Road Crown Compensator

1.Position the bolt through the frame end of the road crown compensator.

2.Position the spacer on the bolt.

3.Install the bolt with spacer and road crown compensator into the mounting hole on the frame.

4.Rotate the fork to ensure the front wheel is pointing directly forward.

5.Position the fork end of the road crown compensator on the fork bolt.

NOTE: If necessary, lengthen or shorten the road crown compensator to position the fork end onto the fork bolt. Refer to Adjusting Road Crown Compensator on page 51.

6. Secure the road crown compensator to the fork bolt with the locknut. Tighten securely.

Recumbent Handcycle Series 50 Part No 1114850