Xerox 4500 ps eth instruction manual Installation of Xerox 4500 PS ETH, Pre-Installation task

Installation

Xerox 4500 PS ETH, Inst. & Operator's Guide

2. Installation of Xerox 4500 PS ETH

When unpacking the unit, record the universal MAC address on the label attached to the rear panel of the unit.

Installation, configuration and changes to the mainframe and LAN of the Xerox 4500 PS ETH must only be carried out by a person with authority and knowledge of the relevant environment.

CAUTION

The interface can be damaged by static discharge. To prevent this damage, the interface comes wrapped in an antistatic bag.

When you remove the interface from the bag and when you install it, hold the interface by the edges only. Do not touch the components or connections.

Do not throw away the antistatic bag. If the interface is removed from the printer later, it should be kept in the antistatic bag.

2.1 Pre-Installation task

Prior to installing the Xerox 4500 PS ETH, you should check that language setting(EU or US language) is correct.

Remaining switches are to be operated by support staff only.

Language setting is performed on the Dip switch bank. The DIP switch bank sits on the interface

2.1.1 EU - US language settings

ON

OFF 1 2 3 4

Dip switch number 2 is used for language setting.

You can select between EU and US language settings.

Should you need to change language setting, set dip switch number 2 as follows:

EU language setting - set the switch to OFF

US language setting - set the switch to ON

15