Xerox 4500 ps eth Configuration using PSinst32, Program Installation Procedure, Program Execution

Configuration

Xerox 4500 PS ETH, Inst. & Operator's Guide

3.3 Configuration using PSinst32

The PSinst32 is a 32 bit i-data program using ida 802.2 to be run under Windows 95 or Windows NT. The program may be used for setting up basic parametersin the PrintServer via GUI panels. The program is designed to complement the other PrintServer configuration tools used for more advanced settings.

This section will limit itself to an outline description. For details you are referred to the extensive Help provided with the program. See the following section.

Firmware download can be done using PSinst32. See the instructions provided in section 3.3.8 “Firmware download”.

3.3.1 Program Installation Procedure

Run the installation file from the first disk and follow the instructions given in the installation program.

NOTE:

You will be asked whether you wish to “install any PrintServer Drivers?”. The drivers referred to here are the various firmwares for the FSL top module.

3.3.2 Program Execution

CAUTION:

To make the PSinst32 program run correctly, you should check that the Microsoft 32-bit DLC network protocol has been installed correctly.

The installation procedure varies from Windows 95 to Windows NT.

See the instructions immediately below:

Windows ‘95 DLC Installation Procedure:

NOTE:

You need to have access to the CD-ROM with your original operating system.

Click “Start” in the bottom left corner of the screen

Click “Settings”

Click “ Control Panel”

Doubleclick “Network”

Click the ”Configuration Form” and check for Microsoft 32-bit DLC

30