Xerox 4500 ps eth Main menu - Where do I start with PSinst32?, Hardware PS Property Form

Configuration

Xerox 4500 PS ETH, Inst. & Operator's Guide

3.3.4 Main menu - Where do I start with PSinst32?

When you have installed the program, you will be met with the Main menu. The main menu has two overall sub-category forms:

-Hardware PS Property Form

From here you enable the protocol(s) of your choice and subsequently make the necessary configuration entries.

-“Monitor” Property Form

When you have selected a DLC download port (LAN), this menu will list all the devices attached to the LAN.

You start your configuration in the Hardware PS Property Form, filling in the basic information such as name and system location needed to identify you as a user. Then proceed to the next section in this manual.

Main Window

Hardware PS

From this menu you will be able to configure your PrintServer.

Monitoring

If you have selected LAN download

(see section 3.3.7), the “Monitor” form will show all discovered devices by MAC address and Name.

Names and system location entered by user

Protocols:

Tick the entry for “Enable” before configuration can take place.

Tick this entry if you wish to boot the PrintServer after download

34