Xerox 4500 ps eth instruction manual “Discover..”, “Refresh”, “Select Adaptor..”, “Download..”

Configuration

Xerox 4500 PS ETH, Inst. & Operator's Guide

The File menu has the following actions available:

Open an existing configuration file

Discover command for new devices on the LAN

Refresh status on existing devices (no new devices)

Switch among various adapters installed locally

When downloading.............

You need to select a target port for download

Below you will find guidelines to the various options listed on this menu

“Discover..”

This function will receive replies from all devices attached to the LAN

The Discover command is also available via the toolbar - look for the icon with the flashlight on it. When you have selected LAN as the download method (see below), the discovery function will receive a reply from the device without any prior configuration.

NOTE:

The discover function puts a heavy burden on network traffic - so use it with care.

“Refresh”

The Refresh command performs a sequential query for all the existing devices on the LAN - i.e. will not see new devices. Allow some time for this process to finish.

NOTE:

Rather use the Refresh command than the discover operation, to ensure low network traffic if you only need to refresh the device status

“Select Adaptor..”

Allows you to switch between different locally installed adaptors.

“Download..”

Allows you to download a file to the PrintServer

40