Xerox 4500 ps eth instruction manual Windows NT 4.0 DLC Installation Procedure

Configuration

Xerox 4500 PS ETH, Inst. & Operator's Guide

-if installed then click “OK” and continue with the installation of Psinst32

-if NOT then continue below:

Click “Add”

Highlight “Protocol”

Click “Add”

Highlight “Microsoft” in the manufacturer window

Click “Have disk”

-insert the “PS configuration, disk 2/2” supplied with the Xerox 4500 PS ETH in drive a:

Click “OK”

Click “OK” and the installation begins

Click “OK” when returning to the “Network Configuration Form”

You are now prompted to insert the CD-ROM with your original operating system mentioned in the beginning. Please follow the instructions given.

When finished, click “NO” to restart of computer

Click “Start”

Click “Run”

Click “Browse” (your floppy drive a:)

Highlight “DLC32UPD.EXE”

Click “Open”

Click “OK”

Click “Yes” to update

Click “OK” to update completely

Remove floppy disk in drive a: and restart the computer

Windows NT 4.0 DLC Installation Procedure:

NOTE:

You need to have access to the CD-ROM with your original operating system.

Click “Start” in the bottom left corner of the screen

Click “Settings”

Click “ Control Panel”

Doubleclick “Network”

Click “Protocol” and check for “DLC Protocol”

-if already install ed, click “OK” and proceed with the PSinst32 installation

-if DLC protocol is not installed then click “Add”

Highlight “DLC protocol”

Click “OK”

31