Xerox 4500 ps eth instruction manual Enabling Idaps, Define SNA

Configuration

Xerox 4500 PS ETH, Inst. & Operator's Guide

Enabling IDAPS

Here the following group parameters are enabled / disabled.

If a group parameter is following the setup definitions for the various sessions, e.g. IPDS input for a session, these must be configured. See the following sections.

BEGIN_CONFIGURATION IDAPS

LOCAL_MAC	4XXXXXXXXXXXX
SEL_MAC	UNIVERSAL
EARLY_TOKEN	NO
ENABLE_TCPIP	YES
ENABLE_NETWARE	NO
ENABLE_802_2	YES
ENABLE_NETBIOS	YES
ENABLE_PU_LU	NO
BOOT	YES
SHARETIMEOUT	20
HOLDTIMEOUT	600
IRQTIMEOUT	60
END

Defining PU_LU

NOTE: The PU_LU session requires the installation of an FSL or IPDS add-on module.

To enable a PU_LU session (SNA), the following keywords are used. The keywords must match the values configured in the chapter ”SCS Printing Using SNA”.

BEGIN_CONFIGURATION PU
BLOCKNUMBER	05D
IDNUMBER	0	(set exchange ID number)
REMOTE_MAC	000	(settheMACaddress of the upstream device)
LOCAL_SAP	4
REMOTE_SAP	4
END

Define SNA

To define a SNA session, see the following configuration example:

BEGIN_CONFIGURATION SNA_PRINT	3
INSTREAM_SNA_PRINT	SCS
END

69