Xerox 4500 ps eth instruction manual Installing into Xerox 4520 printer, For optional use

Installation

Xerox 4500 PS ETH, Inst. & Operator's Guide

2.3.3Installing into Xerox 4520 printer

1.Loosen the “thumbscrews”.

2.Pull out the motherboard from the printer.

3.Dismantle the two blank ets and save the 4 screws for later use (see step 4).

4.Prior to inserting the interface in the motherboard, you are recommended to tighten loosely one screw in the interface’s rear panel and one in the Centronics panel.

5.The interface is to be placed in the slot marked “ A” and the Centronics in the slot marked “ B”.

For optional use

Centronics Interface

6.Now fasten the two screws you loosely inserted in step 3.

7.Fasten the two remaining screws.

8.Re-insert the motherboard into the printer and fasten the “thumbscrews”.

NOTE:

Turn power ON and generate a settings printout - pressing the test key on the rear panel - to check that the connection to the printer has been established.

22