Xerox 4500 ps eth instruction manual Installing into Xerox 4517 printer, Centronics Interface

Installation

Xerox 4500 PS ETH, Inst. & Operator's Guide

2.3.2Installing into Xerox 4517 printer

1.Loosen the “thumbscrews”.

2.Pull out the motherboard from the printer.

3.Dismantle the two blankets and save the 4 screws for later use (see step 4).

4.Prior to inserting the interface in the motherboard, you are recommended to tighten loosely one screw in the interface’s rear panel and one in the Centronics panel.

5.Place the interface in the lower (middle) slot of the motherboard (marked “A”) and place the Centronics cable in the upper slot (marked “ B”).

Centronics

Interface

VOID

6.Now fasten the two screws you loosely inserted in step 3.

7.Fasten the two remaining screws.

8.Re-insert the motherboard into the printer and fasten the “thumbscrews”.

NOTE:

Turn power ON and generate a settings printout - pressing the test key on the rear panel - to check that the connection to the printer has been established.

21