Xerox 4500 ps eth instruction manual Starting the BOOTP Server, E.g.bootpd -b -d -d -d -d -d

Configuration

Xerox 4500 PS ETH, Inst. & Operator's Guide

3.7.3 Starting the BOOTP Server

This section provides you with instructions for starting the BOOTP server.

After making the necessary amendments to the BOOTPTAB file, you are now ready to start the BOOTP server and then verify the configuration by performing a test printout.

1.Start the BOOTP server

Use the BOOTP server debug option (-d) to verify the correct operation.

E.g.bootpd -b -d -d -d -d -d

If the PrintServer and the BOOTP server are not on the same LAN segment, the BOOTP server must be started with the -b option. This enables the BOOTP reply to cross bridges.

2.Power the PrintServer off and back on.

3.After a while, check that the Power LAN LED stays lit.

4.Proceed to section: “Testing PrintServer”.

82