Xerox 4500 ps eth Configuring WRKAFP2 for direct TCP/IP connection, Setting the Chgtcpa, AS400PTF

PSF/400 AFP Printing Using TCP/IP

Xerox 4500 PS ETH, Inst. & Operator's Guide

10.1.2 Configuring WRKAFP2 for direct TCP/IP connection

WRKAFP2 DEVD (PRTPS123 )

RETRY (2)

TCPIP (*YES)

RMTSYS (‘192.0.110.21’)

PORT (5001)

ACTTMR (170)

INACTTMR (*NOMAX)

DEVD This value must match the DEVD in the printer device description.

RETRY Specifies the number of retry attempts to establish a session

TCPIP This value must be set to *YES.

RMTSYS An IP address or a host name may be used for this parameter. In this example, an IP address is used. When configuring the IP address parameter for the Xerox 4500 PS ETH IPC(IPDS), an IP address (and not a host name) must be used.

PORT This value must match the value used for the Xerox 4500 PS ETH (IPDS) TCP port parameter. The Port no. 5001 is the default port number of the first IPDS port on the Xerox 4500 PS ETH (IPDS).

ACTTMR This value specifies the number of seconds PSF/400 will wait for the Xerox 4500 PS ETH to respond to an activation request. If the printer does not respond within this period, PSF/400 will terminate.

INACTTMR This value specifies the length of time PSF/400 will maintain a session with the printer while there are no spooled files with a status of RDY.

NOTE: The values in the WRKAFP2 command vary slightly according

to the PTF level and the operating system version. Consult the following document supplied on the diskette for details:

AS400PTF

10.1.3 Setting the CHGTCPA

If your environment has a need to make certain that a TCP/IP attached device has not been powered off, you may use the TCP KEEP ALIVE parameter in CHGTCPA. This value used for this parameter determines how long PSF/400 will wait for a response from a device before terminating.

115