Invacare XLT Gold, XLTPRO, XLT Jr Adjusting Hand Crank, NOTE For this procedure, refer to FIGURE

SECTION 6—RIDING POSITION

Adjusting Hand Crank

WARNING

DO NOT operate the handcycle if the hand crank obstructs your view. If the hand crank obstructs your view, adjust the height before using the handcycle - otherwise injury or damage may occur.

Adjusting Hand Crank Height - All Models Except Top End XLT Gold

NOTE: For this procedure, refer to FIGURE 6.4.

1.Loosen, but DO NOT remove the two set screws securing the hand crank to the fork stem.

2.Move the hand crank assembly up or down on the fork stem until you are comfortable with the position for operational purposes.

NOTE: The hand crank should be positioned so that when the hand is toward the front of the handcycle, the arm is slightly bent. The arm should NEVER be fully extended (locked) at any point while cranking.

Hand Crank

Set Screws

Fork Stem

FIGURE 6.4 Adjusting Hand Crank Height - All Models Except Top End XLT Gold

3.Tighten the hex nut to secure the hand crank in the desired position.

4.Tighten the chain if necessary. Refer to Adjusting Twenty‐Seven Speed Cassette Chain on page 56.

Recumbent Handcycle Series 34 Part No 1114850