Frymaster FPD, SCFD manual Replacing Rocker Switches, Switch Guard

DECATHLON SERIES GAS FRYERS

CHAPTER 1: SERVICE PROCEDURES

1.7.4 Replacing the High-limit Thermostat (cont.)

9.Remove high-limit from fryer by pulling the capillary tube and bulb through the component box opening (arrow). This may require removal of the control panel frame.

10.Reverse the above steps for high-limit installation.

IMPORTANT: When installing new high-limit or

backup thermostat, ensure the capillary tube and bulb Component box opening (arrow). are positioned properly with the mounting hardware

installed prior to tightening the compression nut. Once

tightened, the capillary tube cannot be repositioned.

1.7.5 Replacing Rocker Switches

1.Disconnect the fryer from the electrical supply.

2.If the switches are located on front panel, remove the screws securing panel to fryer. Do not allow the panel to hang on the switch wiring harness; use some type of support. (Figure A) If the switches are located in a control box within the fryer, remove the screws securing the switch panel to the control box. Do not allow the switch panel to hang from the switch wiring harness. (Figure B)

Switch Guard

Remove screws.

Pass the wires through the switch guard (if applicable) before connecting to switch.

FIGURE A

Remove the screws holding the plate in place, then depress the clips on each end to remove the switch.

FIGURE B

1-19