Invacare XLTPRO, Top End XLT Jr, Force For Models Made After 7/12/07, Firmly tighten the bolt

SECTION 9—OPTIONS

2. Firmly tighten the bolt.

NOTE: Handle should spin freely with minimal play. If handle does not spin freely make sure the spacer is firmly in place. If handle still does not spin freely, contact Invacare.

Bolt	Bearing	Crankarm
		Housing	Bearing

Spacer

Crankarm

Handle

FIGURE 9.10 Installing V/S Crankarm Handles - For Models Made Before 7/12/07

For Models Made After 7/12/07

WARNING

Failure to install handle assembly properly could result in injury.

It is recommended to inspect this assembly prior to and after each use.

NOTE: For this procedure, refer to FIGURE 9.11.

1.Secure the handle to the crankarm housing using the set screw and locknut.

NOTE: Use the right handle, the handle with a mounting post, with the right crankarm and left with left crankarm. The right crankarm has a flange at the base of the crankarm. The left crankarm does not.

2. Firmly tighten the locknut.

NOTE: Handle should spin freely with minimal play. If handle does not spin freely, contact Invacare.

Set	DETAIL “A” - HANDLE
	REPLACEMENT
Screw
	Crankarm Housing
Handle	Locknut
Crankarm

DETAIL “B” - CRANKARM	Mounting
ORIENTATION
	Post
Left	Right
Handle	Handle

Flange

Left	Right
Crankarm	Crankarm

FIGURE 9.11 Installing V/S Crankarm Handles - For Models Made After 7/12/07

Part No 1114850 65 Recumbent Handcycle Series