Invacare XLTPRO, XLT Jr, XLT Gold Installing Hand Crank Handles, Installing V/S Crankarm Handles

SECTION 9—OPTIONS

Installing Hand Crank Handles

NOTE: For this procedure, refer to FIGURE 9.9.

Horizontal Handles/Delrin

Handles

1.Secure handle to hand crank with the screw (Detail “A”).

2.Remove the screw to remove handle from handcrank.

DETAIL “A” - HORIZONTAL HANDLES/DELRIN HANDLES

Hand Crank

Screw

Horizontal Handle

Vertical Handles

1.Position handle onto crank (Detail “B”).

2.Tighten set screw to secure handle to crank.

3.Reverse STEPS 1‐2 to remove handle.

Tri-pin Quad Handles

1.Remove/install tri‐pin quad handles. Refer to Vertical Handles on page 64

2.Loosen socket screws to adjust handle position (Detail “C”).

3.Tighten socket screws to secure handles in desired position.

V or S Crank Handles

Replacement/installation of V or S crank handles should be done by a qualified technician.

DETAIL “B” - VERTICAL HANDLES

Hand Crank

Set Screw

Vertical Handle

DETAIL “C” - TRI-PIN HANDLES

Socket	Tri-Pin
Screw	Quad
	Handle

FIGURE 9.9 Installing Hand Crank Handles

Installing V/S Crankarm Handles

For Models Made Before 7/12/07

WARNING

Failure to install handle assembly properly could result in injury.

It is recommended to inspect this assembly prior to and after each use.

NOTE: For this procedure, refer to FIGURE 9.10 on page 65.

1. Secure the handle to the crankarm housing using the bolt, spacer, and two bearings.

Recumbent Handcycle Series 64 Part No 1114850