Invacare Top End XLTTM Adjusting Back Angle - XLT Gold, NOTE For this procedure, refer to FIGURE

SECTION 6—RIDING POSITION

Adjusting Back Angle - XLT Gold

NOTE: For this procedure, refer to FIGURE 6.10.

1.Loosen, but DO NOT remove, the two socket screws located in the seat angle adjustment clamp.

2.Perform one of the following:

•Increasing Back Angle ‐ While pushing down on the back support tube, push the back down to the desired position.

•Decreasing Back Angle ‐ While lifting up on the back support tube, pull the back upward to the desired position.

3.Securely tighten the two socket screws located in the seat angle adjustment clamp.

Socket Screw

Back Support Tube

Adjustment Holes

NOTE: Wheel not shown for clarity.

FIGURE 6.10 Adjusting Back Angle - XLT Gold

Recumbent Handcycle Series 40 Part No 1114850