Invacare XLTPRO, Top End XLT Jr, XLT Gold Replacing Camber Inserts, Adjusting Toe In/Toe Out

SECTION 7—WHEELS

Adjusting Toe In/Toe Out

1.Loosen, but DO NOT remove the socket screws and clamps that secure camber inserts to the camber bar (Detail ʺAʺ).

2.Slowly rotate the camber insert until the rear wheels are approximately in a straight line.

3.Securely tighten the socket screws and clamps that secure the camber inserts to the camber bar.

4.Measure the distance between the center lines at the rear and front of the rear wheels at approximately 12 inches from the ground/floor. Refer to Determining Toe In/Toe Out on page 44.

5.Repeat STEPS 1‐4 until the toe in/toe out measurement is less than 1/8‐inch (for maximum rollability).

Replacing Camber Inserts

NOTE: For this procedure, refer to FIGURE 7.4.

1.Loosen, but DO NOT remove the socket screws and clamps that secure the camber inserts to the camber bar.

2.Remove the existing camber insert from the camber bar.

3.Install the new camber insert into the camber bar.

4.Adjust the toe in/toe out of the handcycle. Refer to Determining/Adjusting Toe In/Toe Out on page 44.

Clamp

Frame

Camber	Camber Bar
Insert	Socket Screw

FIGURE 7.4 - Replacing Camber Inserts

Part No 1114850 45 Recumbent Handcycle Series