Operating Heater
| Continued |
| ||
| 2 |
|
|
|
P1 | AM | P2 | ON | 3 |
P1 | P2 | OFF | ||
| PM |
| THERMO |
|
|
|
| 8 | |
|
|
|
| |
7 |
|
|
| 4 |
1 | ROOM |
| SET |
|
| PM |
|
| 5 |
|
|
| FLAME |
|
| 6 |
|
|
|
Figure 25 - LCD Display
Buttons
MODE - Changes modes from ON, THERMO and OFF.
DOWN - Lowers set temperature in THERMO mode.
UP - Increases set temperature in THERMO mode
TIME/PROGRAM - Activates time setting and activates PROGRAM mode.
SET - Used to set clock and timer.
Mode
Button
DOWN UP
TIME/PROGRAM SET
Figure 26 - Mode Buttons
Setting the Clock
Slide open plastic cover on front of remote control to expose setting buttons.
The cover protects buttons from being changed accidentally. Close cover after completing the following settings and programming.
1.Press and hold TIME/PROGRAM button on remote control for more than 2 sec- onds. Hour digit(s) will begin flashing.
2.Press UP or DOWN button until desired hour is displayed in AM or PM.
3.Press and release TIME/PROGRAM button again and minute digits will begin flashing.
4.Press UP or DOWN button until desired minutes are displayed.
5.Press and release SET button on remote control to stop time digits from flashing and set the time.
Note: Flashing numbers on display indicate system is awaiting user input, such as using UP and DOWN buttons to program a new setting. If no change is made to flashing dig- its within 15 seconds, system will complete procedure last programmed and reset the display to its normal state.
Setting Fahrenheit and Celsius Scale
Factory setting for temperature is 0° F. To change this setting to 0° C, press UP but- ton and DOWN button on remote control at the same time to change from 0° F to 0° C. Follow this same procedure to change from 0° C back to 0° F.
Manual Function
To operate system in ON manual mode, press MODE button. The flame icon will come on. The word ON and the flame icon will appear on LCD screen in ON mode.
To operate system in OFF manual mode, press MODE button again. The FLAME icon will shut off. The word OFF will appear on LCD screen. The flame icon will not appear on LCD screen in OFF mode.
Thermostat Function
This remote control system can be thermo- statically controlled when remote control is in THERMO mode (THERMO must be dis- played on the screen). To set desired room temperature, press MODE button to place re- mote control into THERMO mode, then press UP or DOWN button to select desired room temperature. Within 5 seconds appliance will turn on or off. The highest SET temperature is 99° F (37° C). The lowest SET temperature is 45° F (8° C). The factory set number will be 45° F (8° C).
If room temperature is higher than 99° F, the word HI will display on the room temperature window frame. If room temperature is lower than 32° F, the word LO will display on the room temperature window frame.
Operational Note: To conserve battery power, changes in room temperature are automatically updated every 2 minutes to remote control. Mode button will operate
Setting Programs
In Program Mode, remote control will allow heater to automatically turn on and off at spe- cific times. Two on and off segments per day may be set, or settings previously programmed at the factory may be used. On and off times are available in 15 minute increments.
www.desatech.com | 17 |