Ryobi RT101 manual Mounting the Table to a Work Surface, See a and 10b

Page 12

ASSEMBLY

MOUNTING THE TABLE TO A WORK

SURFACE

See Figure 10a and 10b.

Follow these directions to mount the table to a work surface.

QPlace the router table right side up on a sturdy work surface, e.g., work stand, workbench, counter top.

QMark the holes with a pencil.

QRemove the router table.

Q Drill four holes through the work surface.

QPlace the router table back on the work surface, aligning the holes in the table legs with the holes in

the work surface.

NOTE: Position the router table surface at approximately hip height.

QInsert four bolts (not included, 1/4-20 recommended)

and tighten securely with lock washers and hex nuts (not included).

NOTE: If you plan to transport the router table to different locations, we recommend that you attach it permanently to a mounting board that you can easily clamp to a work surface.

Fig. 10a

Fig. 10b

12

Image 12
Contents Operators Manual Save this Manual for Future ReferenceTable of Contents IntroductionRules for Safe Operation Read ALL InstructionsRules for Safe Operation Symbols Symbol Name DESIGNATION/EXPLANATIONSpecifications UnpackingInformation Packing ListFeatures Front View Rear View Assembly Assembling the Router TableTo Attach the Fence Attaching the Rear Safety Guard To the Router Attaching the Router to the TableMounting the Table to a Work Surface See a and 10bAdjustments Adjusting Depth of CUTINSERTING/REMOVING Cutters Adjusting the Step Risers Inserting Throat PlatesPositioning the Fence Adjusting the Miter Gauge Using the Router with the Router TableOperation Inserting the Starting PINMaintenance Performing a Routing OperationGeneral Page Service Model NO. and Serial no