ASSEMBLY
WARNING:
The router or router table should never be con- nected to a power supply when you are assembling parts, making adjustments, installing or removing cutters, cleaning, or when not in use. Disconnecting the router and router table will prevent accidental starting that could cause serious personal injury.
ASSEMBLING THE ROUTER TABLE
Assembling the router table involves attaching the legs, the undertable guard, the switch box, the fence, the cutter guard/vacuum attachment, and the miter gauge to the router table.
TO ATTACH THE LEGS
See Figure 2.
Follow these directions to attach the legs.
QPlace router table surface upside down on a flat, level surface with the front edge closest to you.
QPlace each leg in a corner of the table.
NOTE: Two of the legs have been keyed for proper placement. With the table surface upside down, place the leg with four holes and two punched notches in the front left corner of the table and the leg with six holes in the front right corner of the table.
QAlign the four holes in the legs with the four corre- sponding threaded holes in the table.
QUse the hex key to secure each leg with four socket head screws and lock washers.
TO ATTACH THE SWITCH BOX
See Figure 3.
Follow these directions to attach the switch box.
QPlace the router table upside down on a flat surface.
QHold the switch box so that the words ON and OFF on the toggle switch are upside down.
QInsert the switch box through the cutout in the left front leg.
QAlign the two small holes in the mounting tabs with the two small holes in the leg.
QUse a screwdriver to secure the switch box with two thread cutting screws.
TO ATTACH THE UNDERTABLE GUARD
See Figure 4.
Follow these directions to attach the undertable guard.
QPlace the router table upside down on a flat surface.
QPosition the undertable guard around the throat of the table.
QAlign the three holes of the guard with the threaded holes in the table.
QUse the hex key to secure the undertable guard with three socket head screws and lock washers.
Fig. 2
SWITCH
BOX
CUTOUT
Fig. 3
Fig. 4
9